The Improved Overheat Glazing Machine Electric Nail Drill with 6 Bits and Foot Pedal
is professional electric nail machine with easy to use dialing speed control. The nail file can be used for natural as well as artificial nails. You can rest assured purchase!
- New in retail box package
- Compact handpiece easy to grip
- Forward and reverse operation switch
- Rotation speed reaches up to 20,000 RPM
- Extremely quiet and smooth, no vibration when using
- The drill can be controlled by foot pedal / main machine speed control
- Foot pedal for easy operation and comfort
- Improved handpiece cable ending design so that the cable will not loose out easily
- Improved handpiece holding area to prevent overheating during a long period of usage
- Good for pedicure and manicure
- For professional salon use or home use
|Main ( power supply & control ) part
|Rated voltage range
||110 - 120V/ 60 Hz
|Rated power input
|Output rated voltage
||DC 3 - 12V
|Handpiece ( motor ) part
||DC 3 - 12V
|Sanding bands size
||0.6 x 0.8 x 1.3cm ( Inner dia x Outer dia x L )
|Bar of bit size
||2.3 - 3.4 cm ( Length )
1 x Main ( power supply & control )
6 x Bits
6 x Sanding bands
1 x Foot pedal power control
1 x Handpiece
1 x Purple stand
1 x User manual
Installation and wire connection
Connect the 5-pin plug of the portable grinding head/hand piece to the Output socket at the main panel
Connect the pedal switch to the FOOT S/W socket
Select grinding mould of different sizes according to actual requirements, and fasten it into the front of the portable grinding head
Switch the speed control to the left
Connect with the main source power
Press the function switch on the right to hand for manual control, the indicator will be on and the grinding head starts to moving slowly. The diode LED 1-2 will be on.
Turn the speed control to the right to accelerate the grinding head. And all the LED indicators for the speed will be on
When the function switch is pressed to FOOT, step on the pedal, the speed will be accelerated, and loose the foot, the speed will decrease. ( foot switch is optional ).
The turning directions can be swapped. FWD means clockwise direction and REV means counterclockwise direction.
Adjust the speed of the grinding head within a reasonable range.
Please adjust the handpiece to lowest speed before changing forward / backward direction.
Don't change the turning directions too frequently, otherwise, it will damage the grinding head.
Turn the speed control counterclockwise to decelerate the grinding head the minimum before turning off and switch the main power source to 0.
After operation, put the grinding head on the top of the main panel.
While the grinding head is in operation, never pull out the 5-pin plug of the portable grinding head.
For long idle time. Please disconnect the source power.
Any unauthorized disassembling of the product is prohibited. In case of any breakdown, please contact the agent or authorized repair center. We promise swift, high-quality and satisfactory service.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly question in order avoid a hazard.